Furnace and AC Replacement Costs Together in 2026

Cost To Replace Furnace And AC Together in 2026

Replacing your furnace and air conditioner together in 2026 typically costs between $7,000 and $18,000 installed. Most Metro Detroit homes land in the $9,000 to $14,000 range for a mid-range system.

The final price depends on your home’s size, the efficiency level you choose, and the amount of ductwork or electrical work needed. Southeast Michigan’s long heating season and humid summers put stress on both systems, so when one starts failing, the other often isn’t far behind.

This guide explains what a combined furnace and AC replacement costs, when it makes sense to replace both, and what factors change the price for homes in Bloomfield Hills, Troy, Rochester Hills, and nearby areas.

A combined HVAC replacement covers more than swapping two units. It often involves ductwork, electrical connections, permits, and making sure your new equipment matches your home’s heating and cooling needs.

Getting these details right up front can save money and prevent future problems.

Typical Installed Price Ranges

Combined furnace and AC replacement costs vary based on equipment tier, home size, and local labor rates. Most Metro Detroit homeowners see quotes fall into three tiers, with shared labor and a single permit usually making the bundled price lower than replacing each unit separately.

Entry-Level, Mid-Range, And Premium System Estimates

An entry-level system—usually a single-stage 14.3 SEER2 central air conditioner with an 80% AFUE furnace—runs $7,000 to $10,500 installed. A mid-range setup with a two-stage 16–17 SEER2 AC and a 95%+ AFUE furnace costs $10,000 to $14,000.

Premium systems with variable-speed equipment and 97%+ AFUE furnaces can reach $14,000 to $18,000 or more, especially in larger homes. Furnace cost alone often makes up 40 to 50% of the total project, with the AC unit and evaporator coil making up the rest.

What A Complete Installation Usually Includes

A full installation covers the outdoor condenser, indoor furnace, a matched evaporator coil, a new thermostat, refrigerant recovery and charging, electrical hookups, gas line connections, and the mechanical permit. Labor for both units installed together usually costs less than two separate service calls, since the crew is already on site.

Old equipment removal and disposal are typically included in the quoted price.

Why Metro Detroit Quotes May Differ From National Averages

Local labor rates, permit fees, and winter demand push southeast Michigan pricing toward the middle-to-higher end of national ranges. Homes with finished basements or tight mechanical closets may see higher labor costs due to access challenges.

Cold winters mean furnace sizing matters more here than in milder climates, so contractors may recommend slightly higher-capacity equipment.

When Replacing Both Systems Makes Sense

Furnace and air conditioner replacements often line up because both systems tend to wear out around the same age, especially if installed together. Deciding whether to bundle the work comes down to equipment age, shared components like the furnace blower, and whether one system still has life left.

Similar Equipment Age And Rising Repair Risk

Furnaces and air conditioners installed at the same time usually reach the end of their service life within a year or two of each other. Once a system passes 12 to 15 years old, repair costs climb and reliability drops.

If your air conditioner needs a major repair and your furnace is the same age, replacing both now often avoids paying for a big repair on equipment that’s close to failing.

How A Matched System Protects Cooling Performance

Your air conditioner and furnace share the air handler and blower. Installing a new high-efficiency AC with an old blower can reduce cooling performance, since the aging blower may not move enough air.

A matched system—where the AC and furnace come from the same product line—keeps airflow and efficiency as designed and usually comes with a longer labor warranty when installed together.

Situations Where Replacing Only One Unit Is Reasonable

Replacing just one unit makes sense when the other system is younger, under warranty, and running well. A furnace that’s five years old with no repair history doesn’t need to be replaced just because the air conditioner failed.

A licensed technician can check the age, condition, and compatibility of your remaining unit before recommending a full replacement.

Equipment Choices That Change the Investment

The efficiency tier and equipment type you choose have a bigger effect on total cost than almost any other factor. Sizing, SEER2 and AFUE ratings, and whether you consider a heat pump instead of a traditional gas furnace all affect the final price and long-term energy bills.

Selecting AC Capacity With A Manual J Load Calculation

AC tonnage should be based on a Manual J load calculation, not just square footage. This calculation factors in insulation, windows, ceiling height, and local climate to determine how much cooling and furnace BTU output your home actually needs.

Oversized equipment cycles on and off too often, wasting energy and wearing out parts faster. Undersized equipment struggles to keep up during Michigan’s hot, humid summers.

Comparing SEER2 Ratings And Cooling Features

SEER2 measures how efficiently your central AC converts electricity into cooling over a season. A 16 SEER2 AC uses less energy than a 14.3 SEER2 unit, and variable-speed models offer better humidity control, which matters during Michigan’s damp summer months.

Higher SEER2 ratings cost more upfront but lower monthly cooling bills over the system’s life.

Comparing 80%, 95%, And 98% AFUE Furnaces

AFUE, or annual fuel utilization efficiency, tells you how much of your furnace’s fuel turns into heat. An 80% AFUE furnace loses 20 cents of every heating dollar, while a 95% AFUE furnace loses only about 5 cents.

A 98% AFUE furnace is even more efficient. With Michigan’s long heating season, the extra upfront cost of a high-efficiency furnace often pays back through lower gas bills within four to seven years.

Considering Heat Pumps And Dual-Fuel Systems

A heat pump can handle both heating and cooling, but Michigan’s cold winters mean a heat pump alone often needs backup heat below a certain outdoor temperature. Dual-fuel systems pair a heat pump with a gas furnace, switching to gas heat only when temperatures drop too low for the heat pump to run efficiently.

A smart thermostat manages the switchover automatically and can track energy use for both systems.

Site Conditions and Scope Adders

Beyond the equipment itself, several site-specific factors can add to the total cost. Ductwork condition, electrical capacity, and access to the mechanical space all play a role in the final quote.

Duct Repairs, Sealing, And Replacement Decisions

Ductwork in good shape usually needs no extra work, but leaky or undersized ducts can hold back your new system’s performance. Duct repair and sealing typically add a few hundred to a couple thousand dollars.

Ductwork modifications or full replacement can add $1,500 to $8,000, depending on how much needs to be redone. A technician can pressure-test your ducts to see if sealing is enough or if repairs need to go further.

Electrical, Venting, And Condensate Upgrades

Older homes may need electrical upgrades to support a new furnace or air conditioner safely. High-efficiency furnaces often require new PVC venting instead of a metal flue.

Condensate drain lines for high-efficiency furnaces and air conditioners need proper routing to avoid water damage, which can add cost if your mechanical room needs new drainage.

Access Challenges, Code Compliance, And Old-Equipment Removal

Tight basements, attics, or crawlspaces can slow down installation and raise labor costs, especially in older Metro Detroit homes with small mechanical closets. Local code compliance may require updates like a mechanical permit inspection or clearance changes.

Removing and disposing of old equipment is usually included in a quote, but always confirm it’s covered before signing.

Comparing Quotes and Planning the Project

A detailed quote from a licensed HVAC contractor should spell out equipment specifics, labor scope, and any extra charges before work begins. Comparing brands, financing options, and available incentives helps you make a confident decision.

What A Detailed Replacement Quote Should Identify

A solid quote should list the exact furnace and AC model numbers, their SEER2 and AFUE ratings, tonnage and BTU output, and whether the price includes permits, disposal, and startup testing. It should state the labor warranty length and what happens if unexpected issues, like hidden duct damage, come up during installation.

Avoid vague quotes that just say “furnace and AC replacement” without model numbers.

Comparing Brands, Efficiency Tiers, And Warranty Terms

Major brands like Carrier, Trane, Goodman, Amana, Bryant, and Lennox all offer comparable efficiency tiers, though pricing and warranty terms vary. Builder-grade equipment usually costs less upfront, while premium tiers with variable-speed technology cost more but often include longer parts warranties.

Ask each contractor if they’re factory-authorized for the brand they’re quoting, since that can affect warranty registration and service.

Financing, Section 25C Credits, And Scheduling Considerations

HVAC financing can spread the cost of a combined replacement over monthly payments, and many contractors offer this directly. The federal Section 25C tax credit for high-efficiency equipment expired for systems installed after December 31, 2025, so check current state and utility rebates for 2026.

Scheduling a replacement before your system fails gives you more time to compare quotes and avoid rushed decisions during a breakdown.

When To Call A Licensed HVAC Contractor

Replacing a furnace and air conditioner involves gas connections, refrigerant handling, and electrical work that should always be done by a licensed technician. If your system is over 12 years old, needs frequent repairs, or your energy bills are rising, get a professional inspection before deciding.

Frequently Asked Questions

How much should I expect to pay for a new furnace and air conditioner?

Most Metro Detroit homeowners pay between $7,000 and $18,000 for a combined furnace and AC replacement in 2026. The exact price depends on your home’s size, efficiency tier, and whether your ductwork or electrical system needs updates.

A mid-range system for an average home typically lands between $9,000 and $14,000 installed.

Is it cheaper to replace the furnace and air conditioner at the same time?

Yes, bundling both replacements into one project usually saves $500 to $2,500 compared to replacing them separately. You avoid paying for a second permit and labor visit, and you get matched equipment that runs at its rated efficiency.

Staggered replacements also mean mismatched warranty expiration dates later.

What is the average cost of a new HVAC system for a 2,000-square-foot house?

A 2,000-square-foot home typically needs a 3 to 3.5 ton air conditioner with a furnace rated around 100,000 BTU. For that size home, a mid-range combined system usually costs between $10,500 and $15,000 installed.

Exact sizing should come from a Manual J load calculation rather than square footage alone.

How much does a new HVAC system cost for a 1,000-square-foot home?

For a smaller home around 1,000 to 1,500 square feet, a 2-ton air conditioner with a 60,000 BTU furnace is common. The combined installed cost usually falls between $7,000 and $11,000.

Smaller homes typically need less ductwork and lower equipment capacity, which keeps costs down.

What factors affect the price of replacing a furnace and air conditioner?

Equipment size and efficiency ratings like SEER2 and AFUE have the biggest impact on price.

If your ductwork needs repair or replacement, costs go up.

Electrical upgrades, venting changes, and access issues in your mechanical space can also raise the price.

Brand choice and local labor rates matter as well.

What is the $5,000 rule for deciding whether to repair or replace an HVAC system?

Multiply your equipment’s age by the estimated repair cost.

If that number is more than $5,000, replacement usually makes more financial sense than repair.

For example, a 10-year-old furnace with a $600 repair estimate totals $6,000, which points to replacement as the better long-term choice.

Use this rule as a guideline, but consider equipment history and any remaining warranty coverage before deciding.

Scroll to Top